[[email protected]]

So as many of you know I pulled the motor apart on dropouts car! Here are a few pics for the less than satisfactory factory manifolds!

 

[[email protected]]

Yes cats will be available.

 

[[email protected]]

Here is a bit of a sneak peak! I have about 15 hours into what you see in this pic!! These things are tight! I was going for equal length, but I would have 300 hours into just one side if I go for that. Sooooooo........ I'm just going to do a nice flowing set of headers, I have done a bit of the math and it really shouldn't make that big of a difference in power. So here you go!

 

[[email protected]]

He means between pipes of equal length and almost equal. The headers should give good power.

Correct I don't think the difference between equal length and unequal length will be much .

 

[[email protected]]

1 3/8 Piping 16 Gauge... We are thinking the price will be between $1500 and $1800. Coating will be available!

 

[[email protected]]

The engine will most likely need to be removed to get the old ones out!

 

[[email protected]]

Been pretty busy at the shop and I have not had time to get going on the other side! I will have some updates Saturday I hope!

 

[[email protected]]

Sorry guys been super busy at the shop I just need to get a few things done then back to the Headers. I am working on custom pistons for the IS F right now.... That is whats taking time. We will soon be offering 11.8:1 forged factory replacement for those that wanna spray LOTS of nitrous, and 9.0:1 Compression Pistons for boosted applications on the IS F. The Plug and Play AEM F/IC is also almost finished! I have not forgot about you guys just been working hard!