Lexus ISF / IS-F / LFA / LF-A  Forum banner
1 - 3 of 3 Posts

·
LexusF.com SPAM Police
Joined
·
689 Posts
I don't know the exact spec you are looking for. Is the reason for this question of yours because of your car pulling to one side? If so, there is a thread that deals with that to get it within specs all the way around. If that is the case let me know and I will try to find that thread again.
 

·
LexusF.com SPAM Police
Joined
·
689 Posts
glad to see that you found what you were looking for.

As for the constant pulling, when you get your alignments are they able to get it within the tolerances? Here is what I was referring to about the constant pulling, these guys had problems getting the car into the tolerances with a typical alignment. Apparently they had to loosen the subframe bolts and adjust it that way.

http://www.lexusfforum.com/forums/showthread.php?t=1531&page=5

Check post 45...it starts there. Not sure if you saw this before.
 

·
LexusF.com SPAM Police
Joined
·
689 Posts
well after looking back at your links you have posted, looks like you have read that thread/post that I referred to. I couldn't open you link, but it looks like it should point to the same thread.

best of luck. Hope you get it worked out.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top